vRTK GNSS System User Manual
22
1. Hi-Survey Road software – static interface – to set up the static or temporary static mode.
2. Web interface – work mode – to set up the static or temporary static mode.
Users can download the static data file to a computer, if necessary, and then use the static post-
processing software (HBC data processing software package) to process the data.
2.4.2 Static data collection steps
1. Set up the receiver on a control point with a tripod, making sure the tripod is strictly centered and
leveled.
2. Measure the slant height of the receiver three times in three directions, ensuring that the difference
of each measurement is less than 3mm, and then take the average value as the final height. The slant
height of the receiver is measured from the center of the measuring point to the upper part of the top
of the benchmark.
3. Record the point name, S/N, receiver height and start time.
4. Press the power button to start the device and set up the static collecting mode.
5. Turn off the receiver after the static data is collected and record the time.
6. Download and process the static data collected.
Figure 2-4-1Height
2.4.3 Static Data Download
1. Download by USB cable
Connect a computer to the receiver with the Type-C USB cable and copy the static data to it. The
static data is in the GNSS folder of the static drive.
Notice:
Don’t move the tripod or change the collecting set while the receiver is
collecting data.
79mm
