HHP Adaptus Image Kiosk TT8870, Programming Manual

Page: 28 / 149

2 - 12 Image Kiosk™ TT8870 Programming Guide
Multiple Symbols
Note: This feature does not work when the Imager is in Low Power mode.
When this programming selection is turned On , it allows you to read multiple
symbols with a single pull of the Imager’s trigger. If you press and hold the
trigger, aiming the Imager at a series of symbols, it reads unique symbols once,
beeping (if turned on) for each read. The imager attempts to find and decode
new symbols as long as the trigger is pulled. When this programming selection
is turned
Off , the Imager will only read the symbol closest to the aiming beam.
No Read
With No Read turned On , the Imager notifies you if a code cannot be read. If
using a Quick*View Scan Data Window, an “NR” appears when a code cannot
be read. If No Read is turned
Off , the “NR” will not appear.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,”
you can edit the output message using the
Data Formatter (page 4-5). The hex
code for the No Read symbol is 9C.
On
* Off
On
* Off