82
CDR-850
70;
Auto sequence 50 truck forward jump.
71;
Auto sequence 50 truck reverse jump.
72;
High-speed scanning mode which uses auto se-
quence 50 truck forward jump.
73;
High-speed scanning mode which uses auto se-
quence 50 truck reverse jump.
74;
The number of jumps in forward DTRNUM by com-
bining auto sequence 2N truck jump.
75;
The number of jumps in reverse DTRNUM by com-
bining auto sequence 2N truck jump.
76;
REC mode continuance processing after power
failure returns.
78;
Search at blank.
79;
Return mode when "Picup jump" and "Coming off
by focus" are generated in REC.
Error where mechanism contoller is generated.
91;
Loading error.
C7;
Not REC/PAUSE of Power CALIBRATION though
60 seconds passed.
d0;
This product stops for NG or the ST0P key input in
Redum.
d4;
Data has not become complete by TOC and PMA
lead.
d7;
RF check NG at REC/PAUSE.
db;
PMA/REC will not end in 60 seconds.
dd;
This product stops for the TOC check error or the
STOP key input.
d f;
Not REC/PAUSE in 60 seconds, The REC begin-
ning cannot be done in ten seconds.
The return after Picup jump will not end in 60 sec-
onds.
F0;
mechanism contoller communication error.
F1;
mechanism contoller hardware error : In this case,
the NG pin number of mechanism contoller is dis-
played in TRACK.
F2;
mechanism contoller A/D input (RFT,RFB) error.
F5;
Serial Namber error forRID.
Two digits displayed in
3
: Recording sub-mode when error
generation is done.
10:
REC/PAUSE is being set.
: Other states when the error generation
is done are displayed by the HEX code.
Synchronization coming off is detected at REC.
TOC lead error (Data does not become complete).
The A/D value is abnormal of RFT and RFB.
bit2:
There is no meaning.
bit1:
There is no meaning.
bit0:
There is no meaning.
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
