Chapter
5
5 Installation
5.1
Ultrastar 8 Installation Overview
Table 17: Procedure Info
Time
Required
# of People
Required
Required Parts
Required Tools
45 min.
3 Total (2 for Team
Lifting Purposes
•
•
M5 x 10mm T15 Torx
screws
Long T15 Torx Screwdriver
• # 2 Philips Screwdriver
and 1 to Guide and
Spot)
• M5 x 12mm Phillips Pan
Head screws (to secure
top cover)
• Long T10 Torx Screwdriver
• Tape Measure
• Level
• Included Washers
• Low-Profile M4 x 3.2mm
Philips screws (included
with rail assembly)
• M3 x 8mm T10 Torx
screws
• 10 M5 cage nuts
• Zip Tie (from CMA box)
Table 18: Torque Specifications for Screws
Torque Value
Screw Type
3.38-3.61 Nm / 30-32 in-lbf
M5 x 10mm T15 Torx screws
3.38-3.61 Nm / 30-32 in-lbf
M5 x 12mm Phillips Pan Head screws
.90-1.12 Nm / 8-10 in-lbf
Low-Profile M4 x 3.2mm Philips screws
.33-.56 Nm / 3-5 in-lbf
M3 x 8mm T10 Torx screws
5.2
Ultrastar 8 Installation Procedure
1.
Remove the inner rail that is nested inside the rack rails.
Note: There are Right and Left rails and they must be installed as a set. Each inner rail will read
"R" for the right or "L" for the left embossed on the inside. Each outer rail will read "R-Front" for
the right or "L-Front" for the left. Right and Left refer to when you are facing the front of the rack.
a) Start by sliding the inner rail out of the outer/rack rail until the safety latch engages and the inner rail
will not extend further. It will only slide one way.
33
5
Installation
Installation Guide
5.1
Ultrastar 8 Installation Overview
