HEX-BEAM SP7IDX MARK IV HD, Instructions Manual

Page: 20 / 68

20
Attention !
correct wire tension adjust with black handle fixing left or right,
Do not tighten the wire too much, The wires should be a little slack
do not screw it tightly, not the wheel from the car !!!
Only minor adjustment is required if any, for proper tension of the wires.
Not to tight, not to much sag of the wires. After all we must realize
that my measurements are estimates too.
Bear in mind that
these are only preliminary clip locations and
when the beam is installed, minor adjustments
might be needed to get the wire tensioned right.
Typical placement of Wire Guide Clamps