9.
Install the FlexibleLOM riser cage
on page 31.
11. Install the server into the chassis
on page 29.
12.
Connect the LAN segment cables to the adapter.
13.
Connect all peripheral cables to the server.
The installation is complete.
Expansion board options
Installing an expansion board in the primary riser cage
The primary riser slot only supports low-profile expansion boards. For more information on this riser
option, see
Primary riser board components
on page 17.
CAUTION:
The maximum inlet ambient temperature for most components installed in the system is
35°C (95°F). Some components, however, are subject to thermal limitations depending on the
chassis model and the fan configuration. There are some hardware configurations where it is
necessary to limit the number of drives installed in the chassis. For more information, see
.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
2.
Disconnect all peripheral cables from the server.
3.
Remove the server from the chassis
on page 28.
4.
on page 30.
66
Hardware options installation
