Hewlett Packard Enterprise ProLiant ML350 Gen10, User Manual

Page: 116 / 214

◦
NVMe SSDs
◦ M.2 SSDs
◦ SFF SAS drives with 10K or 15K rpm rate
◦ Smart Array P-class 800-series Gen10 controllers*
◦
GPUs*
◦ HPE EDR InfiniBand adapters*
◦ High-performance NIC controllers*
For specific models covered by the options marked with an asterisk (*), see the product QuickSpecs on the server
website at
https://www.hpe.com/servers/ml350-gen10.
• ASHRAE A3 and A4 compliant configurations
For more information, see the
Hewlett Packard Enterprise website.
Fan population and hot-plug support
The number of fans installed in the server determines fan redundancy. When redundant fan mode is enabled, hot-plug fan
operation is supported.
In this server, fan operation can either be one of the following:
• Hot-plug – A failed fan can be replaced without powering down the server
• Non-hot-plug – To replace a failed fan, the user must either:
◦ Keep the server powered on and complete the fan replacement within 30 seconds of opening the access panel, or
◦
Power down and disconnect all power from the server before removing the access panel for fan replacement.
Bay 1 Bay 2 Bay 3 Bay 4 Bay 5 Bay 6 Redundant
hot-plug
support
— — — — Fan Fan No
Blank Fan Fan Fan Fan Fan No
Fan Fan Fan Fan Fan Fan Yes
Fan mode behavior
• In non-redundant fan mode, a fan failure or a missing fan causes:
◦ The system Health LED to flash amber.
◦ The operating system to orderly shut down.
• In redundant fan mode:
◦ A fan failure or a missing fan will switch the system to non-redundant fan mode.
116
Hardware options installation