Hewlett Packard Enterprise HPE XP7, User Manual, Page: 195 / 311

Pair task RAID Manager command RWC
raidcom delete snapshot
Assign an S-VOL to
snapshot data raidcom mount snapshot Create FS Pairs wizard
Assign Secondary Volumes
wizard
Release the assignment of
an S-VOL to snapshot data raidcom unmount snapshot Remove Secondary Volumes
window
Change the assignment of
an S-VOL to snapshot data raidcom replace snapshot Assign Secondary Volumes
wizard
For more information about using the RAID Manager, see the HPE XP Storage RAID Manager Reference
Guide .
RAID Manager pair command results
The following table shows the results of running commands on pairs depending on their status.
Status RAID Manager command
paircreate paircreate
-split
pairsplit pairresync pairresync
-restore
pairsplit -
S* pairsplit -E
SMPL Ok Ab Ab Ab Ab Np Ab
COPY Np Ab Ab Np Np Ab Ab
PAIR/PFUL Np Ok Ok Np Np Ok Ab
PSUS/
PFUS Ab Np Np Ok Ok Ok Ab
RCPY Np Ab Ab Np Np Ab Ab
PSUE Ab Ab Ab Ok Ab Ok Ab
*Terminates normally, regardless of the pair status, when the snapshot tree is specified as the range to
be deleted.
Legend:
Ok: The command ends normally and the task is performed.
Np: The command is not rejected and ends normally but the task is not performed.
Ab: The command is rejected and ends abnormally.
Do not specify noread mode (-m noread) for S-VOLs using RAID Manager. If you do, the command ends
normally but the noread mode does not take effect.
RAID Manager pair command results 195