Removing and replacing the M.2 SSD
Prerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
Procedure
on page 29.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
• Server in rack mode:
Remove the server from the rack
on page 30.
Position the tower server for hardware configuration
on page 31.
on page 34.
7. Remove the system air baffle
8. Remove the M.2 SSD enablement board
9.
Remove the M.2 SSD.
To replace the component, reverse the removal procedure.
Removing and replacing an expansion board
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all
PCI slots have either an expansion slot cover or an expansion board installed.
Removal and replacement procedures
57
