Chapter 2
Components
11
To observe disk LEDs during enclosure operation, you must remove the enclosure bezel. Optionally, you can monitor
disk activity using management interfaces when the bezel is attached.
NOTE A partial assembly view shows bezel insertion into the right ear hubcap slot. Simplified conceptual graphics
illustrate the enclosure bezel attachment procedure.
Figure 2 Attaching/removing the enclosure front bezel
TIP To remove the bezel from the enclosure, reverse the order of the steps previously provided.
See also,
"Enclosure bezel assembly" on page
for a partial exploded view showing alignment of enclosure bezel
components.
The front panel illustrations that follow show the enclosures with the bezel removed, revealing disk modules.
24-drive controller enclosure or expansion enclosure
Figure 3 24-drive enclosure shown with hubcaps only (no bezel)