AP-303H-MNTW Wall Mount Kit
Installation Guide
05119
80
-0
2
|
April 2017
1
Package Contents
AP-303H-MNTW plastic mount bracket
(2) Blank Keystone jack cover
(2) #6-32 x 1.5” slotted screws
M2.5 x 0.45P x 6.5 security screw
AP-303H-MNTW Wall Mount Kit Installation Guide
Introduction
The AP-303H-MNTW wall mount kit provides the materials required to mount a 303H access point to
a flat surface or single gang wall box.
Refer to the following section for complete installation instructions.
Installing the AP-303H-MNTW
This section contains instructions for installing the AP-303H-MNTW wall mount kit.
To install the mount bracket onto a flat surface, see
Installing the AP-303H-MNTW to a flat surface
. To
install the mount bracket onto a singlel gang wall box, see
Installing the AP-303H-MNTW to a wall box
.
Installing the AP-303H-MNTW to a flat surface
1. Choose the desired location to mount the AP-303H-MNTW, then mark and drill pilot holes into the
mounting surface.
2. Position the mounting bracket flat against the surface so that the pilot holes align with
corresponding screw holes , then screw the bracket into place, as shown in
Figure 1
.
3. Use the RJ45 jumper cable provided to link the E0 and PT ports located on the back of the access
point.
Before installing the AP-303H-MNTW Wall Mount Kit to any surface, ensure that the mounting surface can support
the combined weight of the mount kit and access point.
Screws for Step 2 are not provided in this kit. The screw used for this step will vary depending on the surface.
