MF877-00 Page 2
Template Revision A
HPE instructions for this template are available at
Item Description
Notes
Quantity
of items
included
in product
Components, parts and materials containing
refractory ceramic fibers
0
Components, parts and materials containing
radioactive substances
0
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Tool Size (if
applicable)
Phillips Screw driver
#2
Phillips Screw driver
Phillips Screw driver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove Bezel (located at front of unit, No tools required.) Dispose of components properly.
2. Remove screws from Battery Cover.
3. Remove Battery Packs and set aside.
4. Remove retaining screw from EM.
5. Remove EM and set aside
6. Cut the external power cord with cutting tool. (Located on rear of unit).
7. Remove screws from X-Slot cards and remove X-Slot cards (If installed).
8. Remove screws from Rear Panel
9. Remove Top Cover by sliding towards rear of unit.
10. Caution: Be sure the Battery Packs are removed before continuing or risk of electrical shocks exists. Cut wires retaining
the Rear Panel. Remove and disassemble.
11. Cut wires from Power I/O and Signal I/O and remove.
12. Remove X-Slot enclosure by squeezing and lifting off.
13. Remove capacitors greater than 2.5 cm.
14. Separate the Power I/O and signal I/O assemblies and discard components properly.
15. Remove EMI Board and discard components properly.
16. Remove screws from front of EM and remove 4 screws on side and 2 nuts next to Fans.
17. Slide the lid away from fans and separate. Remove Fans with metal support bracket.
18. Remove cables by unplugging or by using cutting tool.
19. With flat head screwdriver pry capacitors greater than 2.5 cm, remove and discard properly.
20. Remove boards and dispose of components properly.
21. Disassembly of Battery Module Caution: Avoid wearing jewelry during disassembly that can be exposed for electrical
shock. Caution: Batteries are an energy hazard and can cause shock, or burn from high short circuit current. Observe
proper precautions.
22. Expose battery connections by lifting plastic covering. Cutting tape as necessary.
23. Remove battery Terminals and wire harness
24. Remove battery connector and harness. Dispose of components properly.
25. Remove batteries from plastic covering. Dispose of components properly. Batteries should be disposed of at a local
recycling /reuse or hazardous waste center.