en
Rev. 03 / 02.2021
AB3200
64 / 88
Software description
-] Settings
PROG
T/°C
RCF
RPM
t/min
Ramp Unit = Steps / Time
PROG
T/°C
RCF
RPM
t/min
Store Settings...
PROG
T/°C
RCF
RPM
t/min
-] Settings
PROG
T/°C
RCF
RPM
t/min
RCF Integral = on
PROG
T/°C
RCF
RPM
t/min
Store Settings...
PROG
T/°C
RCF
RPM
t/min
7.3.5.5
Ramp Unit
Further information on page 55
Activate/deactivate the start-up and run-down times as follows:
1.
Change to the menu
‘Machine Menu
🠂
Settings’
2.
Press the
[PROG] key until the ‘Ramp Unit’ parameter is displayed.
3.
Set
‘Steps’ or ‘Steps / Time’ using the [adjusting knob].
‘Steps’
Start-up and run-down times deactivated.
‘Steps / Time’
Start-up and run-down times activated.
4.
Press the
[START] key to save the setting.
5.
[STOP/OPEN] key Press 1x
⇒
Back to the menu
‘Machine Menu’.
6.
[STOP/OPEN] key Press 1x
⇒
Back to the main display
7.3.5.6
RCF Integral
Further information on page 55
Activate/deactivate the display of the integral RCF as follows:
1.
Change to the menu
‘Machine Menu
🠂
Settings’
2.
Press the
[PROG] key until the ‘RCF Integral’ parameter is displayed.
3.
Set
‘on’ or ‘off’ using the [adjusting knob].
‘on’
Integral RCF activated.
‘off’
Integral RCF deactivated.
4.
Press the
[START] key to save the setting.
5.
[STOP/OPEN] key Press 1x
⇒
Back to the menu
‘Machine Menu’.
6.
[STOP/OPEN] key Press 1x
⇒
Back to the main display
7.3.5.7
B-Ramp
No B-brake stages can be set for this device. It is not pos-
sible to activate the B braking levels in the ‘Settings’ menu
(parameter ‘B-Ramp = off’). B-brake stages are similar to
an exponential braking curve.
