-14-
■ Connector Use
Connection
Disconnection
· Turn off the power source
· Make sure red dot on the cable's plug faces upward
· Push the plug straight into the LiDAR's socket
· Turn off the power source
· Hold the plug's shell and pull the plug from the socket
NOTE
· DO NOT attempt to force open a connection by pulling on the cables or by twisting the connectors in any way. Doing so can loosen the
connectors' shells, or even damage the contacts.
· In case a connector's shell is accidentally pulled off, stop using the connector and contact Hesai technical support.
· DO NOT attempt to assemble the connector's shell and cable collet; DO NOT connect a connector without its shell. Doing so may damage the
LiDAR's circuits.
Figure 2.5 Lemo Connection
■ Cables
OD (outside diameter) = 5.0±0.2 mm
Minimum bend radius: 10 * OD
NOTE To avoid damaging the cable, do not bend the cable at the cable gland.
Before connection: make sure the red dot faces upward
