Part Number 3080006.001, Rev. D
©2012, HES, Inc.
3
3
Transfer the location of the inside wall of the cabinet to the door.
3a. Measure the
horizontal distance between the
inside edge of the cabinet and the door edge.
3b. Using the same distance away from the door edge, draw a line on the
inside
surface of the door.
This line depicts the location of the strike mounting surface.
Drill
4
Place and use the Lock Template.
4a. Peel off the protective layer of the Lock Template
and align to both the latch centerline and the line
depicting the inside wall of cabinet. Press to secure.
4b. Drill four holes through the cabinet, as shown. Two
holes are 5/32” diameter and two are 1/2”
diameter.
4c. Remove the lock template from the door.
5
Place and use the Reader Template.
5a. Peel off the protective layer of the Reader Template
and align it to both holes drilled in the previous step.
5b. Drill
only one
5/32” hole depending on the desired
antenna/reader orientations (see below).
5c. Remove the Reader Template from the door.
NOTE:
Some antenna/reader orientations may prevent use of the key
override function. For example, in the door handing shown here,
manual override cannot be used in orientation “A”, but it can be
used in orientations “B” and “C”.
3a. Cabinet/door front
view
when
3.b
4a. Align and place template.
4b. Drill.
5a. Align template to existing holes.
5b. Drill only
one
hole of the three
possible antenna/reader orientations
A
w
he
n
B
w
he
n
C
w
he
n
Door edge
Measure the
distance from
the inside edge
of the cabinet
to the edge of
the door.
3b. Draw a line on the door that depicts the
location of the inside edge of the
cabinet
when
Mark the location of the
inside wall of the cabinet
to the door.
A
w
he
n
B
w
he
n
C
w
he
n
