Herz pelletfire, Operating Instructions Manual

Page: 53 / 96

Description of the menu navigation and adjustment values 11
Betriebsanleitung_pelletfire_Touch_Englisch_V1.2 53
Term Description Unit
Status
   
Hydr. compensator
temperature
Display of the temperature in the hydr. compensator

In the hydr. compensator is a temperature sensor which measures
the temperature in the hydr. compensator
°C
Existing temperature
Display of the flow temperature of the preceding module (e.g. boiler,
buffer)
°C
Required temperature
Display of the required temperature of the downstream module (e.g.
heating circuit)
°C
Pump 1
Indication of the state of pump 1 (ON/OFF)

Pump 1 is the pump in the back flow on the primary side
-
Pump 2
Indication of the state of pump 2 (ON/OFF)

Pump 2 is the pump in the flow on the secondary side
-
Settings
   
Switch on barrier
Setting the switch on barrier for pump 2:

Is the flow temperature of the preceding module (e.g. boiler, buffer)
higher than the adjusted switch on barrier, pump 2 is switched on. Is
this not the case, pump 2 stays switched off.
°C
Temp.increase
Adjusting the temperature increase for the required temperature

Due to heat losses you can adjust an addition to the required
temperature of the downstream module
°C
Agg-Test
   
Pump 1*
Indication of the state of pump 1:

Pump 1 is the pump in the back flow on the primary side

When the indicator lamp lights up pump 1 is switched on
-
Pump 2*
Indication of the state of pump 2:

Pump 2 is the pump in the flow on the secondary side

When the indicator lamp lights up pump 2 is switched on
-
MODUL
Boiler Buffer Hot water tank Heating circuit Time mode
Solar Hydr.compensat Net pump Zone valve
Ext. requirement
addit. boiler