2
Warning notes
6
1.3.3
Maintenance
Before starting to carry out any work on the
system, but especially before opening covers
protecting live parts, the system is to be properly
disconnected from the power supply. Besides the
main circuits, attention is also to be paid to any
existing additional or auxiliary circuits in the
process. The normal safety rules according to
ÖNORM are:
◼
Disconnect all poles and all sides!
◼
Ensure that the system cannot be
switched on again!
◼
Check to ensure that no voltage is
connected!
◼
Earth and short-circuit!
◼
Cover adjacent live parts and locate
hazardous areas
These
above-mentioned
measures must not be reversed
until the system has been fully
installed and maintenance has
been completed.
Personal dust masks and gloves
must be worn when carrying out
maintenance in the combustion
chamber or the ash collector or
on flue gas-carrying parts and
when emptying the ash container,
etc.!
Extra-low-voltage lamps are to be
used
when
carrying
out
maintenance in the fuel storage
room. Electrical equipment in the
fuel storage room must be
designed in accordance with
ÖNORM_EN_ISO_20023!
In order to prevent any maintenance errors, if
maintenance is not carried out properly, it is
recommended to be carried out regularly by
authorised personnel or by the HERZ Customer
Service department.
Spare parts must be obtained directly from the
manufacturer or a distribution partner. Due to the
noise caused by the machine, the customer is not
exposed to health risks.
2
WARNING NOTES
Risk of injury and damage to
property
due
to
improper
handling of the system. Damage
to property is possible.
Caution
– hot surface
Warning
– against hand injuries.
No
admittance
without
authorisation.
However,
adherence
to
guidelines
for
transportation,
installation,
operation
and
maintenance notices as well as technical data (in
the operating instructions, product documentation
and on the equipment itself) which are not
specifically highlighted, is also vital to avoid
breakdowns which may directly or indirectly cause
major personal or material damage.
General safety notes
For reasons of clarity and possible permutations,
this documentation does not contain all detailed
information and cannot take account of every
conceivable operating or maintenance scenario.
Should you require further information or
encounter specific problems, which are not
handled in detail in the documentation supplied,
you can obtain the required information from your
specialist dealer or direct from HERZ.
People (including children) who, because of their
physical, sensory or mental capabilities or
because of their lack of experience or knowledge,
are unable to use the equipment safely must not
use this equipment unless they are supervised or
instructed by a responsible person.
Summary of Contents for firematic CONDENSATION 30
