Herutu TW-800R-EXL, Manual

Page: 16 / 28

TW-800R-EXL
14
DIP switch 2 (Extension unit side)
DIP switch 2 - 1 and 2 of the extension unit set the communication speed and flow control of the internal
CPU
⇔
XPort.
In this receiver, since the setting between built-in CPU and XPort is done at the time of shipment, if there
is no special reason, please do not change the setting.
◆
Baud rate setting
◆
Flow control
◆
Ethernet output data type setting
The data size varies depending on the set values.
Fo
r details of each data format, refer to “Network communication”.
*DIP switch 2 - 3, 4 and 6 are not used.
*Caution
・
When the signal from another transmitter is received while the receiver was carrying out the relay output,
the relay output for transmitters received later is not performed. LAN output is performed respectively.
・
When a receiver receives the signal from same transmitter during double count prevention time, relay
output time, and buzzer sound, a receiver does not process a signal but transmits the "BUSY" signal to a
transmitter.
When a transmitter receives “BUSY” signal to a receiver, Green LED of transmitter flashes 4 times.
・
When the signal from another transmitter is received while buzzer of receiver sounds, the buzzer
sounds for transmitters received later is not performed. LAN output is performed respectively.
・
The receiver holds the data from a transmitter until each processing (a relay output and the prevention
from a double count) is completed. A limit is among the quantity which a receiver can hold temporarily,
and when the signal from the transmitter exceeding the number of maintenance limits of another ID is
transmitted before each processing was completed, a receiver may transmit the "BUSY" signal to a
transmitter.
(
When a transmitter receives “BUSY” signal to a receiver, Green LED of transmitter flashes 4 times.)
When you set up relay output time and double count prevention time in long time, please be careful.
DIPSW 1
(38400bps) (ON)
19200bps OFF
DIPSW 2
Flow control no using ON
Flow control (RTS/CTS) using (OFF)
DIPSW 5
Long data ON
Short data OFF
<-Factory setting (Please do not change)
<-Factory setting (Please do not change)
<-Factory setting