Herutu TW-510T, Instruction Manual

Page: 23 / 32

17
8.Precautions during use
8.Precautions during use
・
This machine is the precision equipment covered with plastic frame. Do not
give an excessive impact.
・
Use a care during setting as the Dip Switch for setting ID can be easily
damaged. Carefully make setting using the edged tool like Prick punch.
・
Shift the battery to the arrow mark side before disconnecting the battery.
・
Do not use the edged tool like prick punch when pressing the Test switch.
（
Use an extreme care not to damage the Pawl of Battery holder during
replacement of battery.
）
・
Use a care not to bite the cable of Limit switch when replacing a battery or
changing the ID setting.
■About the reliability of the wireless communication.
Wireless communication has the aptitude different from Wired, and generates a
Wireless communication error by following factor.
・
Over the wireless communication length
・
There is entered dead point.
・
There is a strong jamming beam.
When it's a problem on the practical use to be interfered with later when being frequently
interfered with, please use after use is canceled and the cause of the interference is
excluded. The situation that a wireless communication can't also be received besides the
above factor occurs, so after understanding beforehand, please use.
※
A sent radio wave influences a reflected radio wave on a wall from a transmitter, and
dead point is the area a radio wave becomes weak extremely where.
It can't sometimes be received by simultaneous sending * done case and receiving
equipment from more than 2 transmitters in the same channel (frequency).
Even if the ID setting is made different setting for a phenomenon by intervention of
the frequency which is being transferred by air, it isn't possible to settle the same
symptom.
When practical use like the above is assumed, it's necessary to correspond by
channel change, so please even consult about our Sales Division.
*: Sending at the same time within about 0.5 seconds with the simultaneous sending I say
here is meant.
When shipping a transmission channel of a this machine only by 1 wave, it'll be
fixing. It isn't possible to receive a signal by a receiver in a channel different from a
transmitter.