21D-265C
48
Applied operation
7. Applied operation
This article describes the operation methods other than those mentioned in
“6. Basic
operation
”.
The contents stated here are mainly the different points from those in Basic operation, but the
same points as those in Basic operation are not contained. Accordingly, make settings for
those different points according to the Basic operation.
The operation described here consist of the working setting (1)-(3) and (A)-(C).
The working setting is largely classified into:
①
“
Yes
”
or
“
No
”
for registration of Working hour
(Function settings command [6])
②
“
Yes
”
or
“
No
”
for use of Tact reserve function
(Function settings command [5])
Besides, when
②
Tact reserve function is used, the display method is divided into:
①
”Yes” for use of Cumulative display
②
”Yes” for use of Individual display
To change the working setting, use the commands [5] [6] in the Function
settings(Page-10). Precisely set depending on your application.
For the Working setting (1), see the Basic operation.
With
Working hour
With Tact reserve function
Individual
display
Cumulative
display
Without
Working
hour
Without Tact reserve function
With
Tact
reserve
function
Individual
display
Cumulative
display
Function settings command [6]
Function settings command [5]
Function settings command [5]
Working setting
（
1
）
（
M=1
）
Without Tact reserve function
Working setting
（
2
）
（
M=2
）
Working setting (A)
(M=A)
Working setting (B)
(M=B)
Working setting
（
3
）
（
M=3
）
Working setting (C)
(M=C)
