GB
8
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout and items supplied
(Fig. 1-6)
2.1 Layout
1. Miter
stop
2. Parallel
stop
3. Wheel
guard
4. Cutting
table
5. Water
trough
6. Housing
7. Knurled screw for setting the angle
8. Scale for miter cut
9.
Knurled screw
10. Thumb screw
11. Holder for splitter
12. On/Off switch
13. Switch housing
15. Diamond cutting wheel
16. Outer flange
17. Side cover
18. Nut
19. Splitter
20. Fastening screws for splitter holder
2.2 Supplied package
the packaging and take out the equipment with
care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Original operating instructions
Safety information
3. Technical data:
Motor rating:
600 W S2 10 min
Motor speed:
3000 rpm
AC motor
230 V ~ 50 Hz
Insulation material class
Class B
Protection type
IP 54
Protection class
I
Cut length:
Unlimited
Jolly length:
Unlimited
Cutting height 90°:
35 mm
Cutting height 45°:
12 mm
Cutting table-Dimensions
330 mm x 360 mm
Diamond cutting wheel
ø 180 x ø 25.4 mm
Weight: 10
kg
A load factor of S2 10 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (600 W) for no longer than
the time stipulated on the specifications label (10
minutes ON period). If you fail to observe this time
limit the motor will overheat. During the OFF period
the motor will cool again to its starting temperature.
Idle speed
L
pA
sound pressure level
97.3 dB
L
WA
sound power level
110.3 dB
Anleitung_H-FS_518-2_SPK7:_ 14.10.2011 8:20 Uhr Seite 8