Heras HMD Basic, User Manual

Page: 66 / 88

EN – Translation of the original user manual - 2.0 | 2019 66
FAULTS 8
8.1 DEFECTIVE PHOTOCELL OR SAFETY EDGE
If a photocell or safety device is defective, the gate can only be opened and closed
using the hold-to-run switch. In this case, consult a qualified technician.
See chapter “SERVICE / MAINTENANCE”
8.2 PARAMETERS REFERENCE/ERROR NUMBERS
The possible entries in the log system described above for events and/or errors
are listed in the table below:
Reference/
Error no.
Text Meaning
25 Fixed.StripOPEN Fixed safety contact strip OPEN was activated
(a ‘0’ is stored immediately after the text if the
motor was not active)
26 Fixed.StripCLOS
E
Fixed safety contact strip CLOSE was activated
(a ‘0’ is stored immediately after the text if the
motor was not active)
27 Acc.StripOPEN Accompanying safety contact strip OPEN was
activated
(a ‘0’ is stored immediately after the text if the
motor was not active)
28 Acc.StripCLOSE Accompanying safety contact strip CLOSE was
activated (a ‘0’ is stored immediately after the
text if the motor was not active)
40 Light barrier The light barrier was activated during the CLOSE
movement
86 Number of
reversals The maximum number of reversals for a
movement direction (without reaching the limit
position) was reached
130 Scstrip
OPENtsterr Error in test result for the fixed safety contact
strip OPEN was detected
131 Scstrip CLOSE
tsterr
Error in test result for the fixed safety contact
strip CLOSE was detected