Heras HGD230, User Manual

Page: 82 / 146

EN – Translation of the original user manual - 2.1 | 2019 82
• Switch on the power supply to the motor drive while a chipcard is
inserted.
• Indication: "I2C SmartCard".
•
Turn the selector switch in a clockwise direction; you will now see the
message: "copy Card->CTRL"
•
Press the selector switch to start copying: "copy …."
•
When copying is finished the following message is displayed: "copy
DONE".
•
Removing the card from the reader restarts the motor drive with the
newly loaded parameters.
Note!: Errors that occur during copying are reported by means of "Card
Comm. ERROR".
You can try to read the chipcard again by turning the selector switch and pressing
it. If this does not work, all parameters will be erased by the software when the
chipcard is removed. The HMD230 shows "Init/Clear EEPROM" and then "Load
Parameter". The contents of a card have to be read then again. The motor drive
does not work without correct parameters.
7.19 SUPPORT DURING DIAGNOSIS
The HMD230 has a diagnostics menu that makes putting the motor drive into use
and troubleshooting easier.
7.19.1 Version display
The motor drive version can be displayed as follows:
• Menu: "Identification", "Master Version": the figures and the combination
of numbers shown clearly identifies the software version used.
• Menu: "Identification", "Gate profile": the text shown is the designation of
the gate for which the master drive, the software and the parameters
stored have been defined.
•
Menu: „Identification“, „Serial number“: The serial number of the control
is shown here.
The following version parameters are visible after entering the right password: