English
28
13. Troubleshooting
WARNING:
Always remove the battery pack when servicing or transporting the mower.
Always protect your hands by wearing heavy gloves or wrapping the cutting edges with
rags or other materials when performing any maintenance on the mower blade.
PROBLEM
CAUSE
SOLUTION
The mower
fails to start
• The battery pack is depleted.
• The battery pack is not
mounted in place in the battery
compartment.
• The battery or mower circuitry
is too hot. (The power indicator
on the mower will blink slowly
for 7 times)
• The side rails are not extended
to their maximum length and
the clamps are not locked in
position.
• The handle is not set at one of
the three operating positions.
• The mower deck is clogged with
grass and debris.
• Charge the battery pack.
• Attach the battery pack to the
mower. Press it until you hear a
click.
• Allow the battery pack or
mower to cool until the
temperature drops below
152°F (67°C).
• Fully extend the handle and
lock both clamps.
• Adjust the handle to one of the
three operating positions.
• Clean the mower deck and
make certain that the blade
has freedom of movement.
The mower
cuts unevenly
• The blade is dull.
• The cutting height is not set
properly.
• The blade is assembled
incorrectly.
• Sharpen or replace the blade.
• Move the deck height to a
higher setting.
• Reassemble the blade,
following the section “Installing
the blade” in this manual.
The mower
stops while
mowing
• The battery pack is depleted.
• Mower is in overload condition.
• Mower deck is clogged with
grass and debris.
• The battery or mower circuitry
is too hot. (The power indicator
on the mower will blink slowly
for 7 times.)
• The side rail is retracted a little
by the pushing force applying
on the handle.
• Charge the battery pack.
• Raise the cutting height or
slow down the mowing.
• Unclog the mower deck. Raise
the cutting height, or cut a
narrow swath.
• Allow the battery pack or
mower to cool until the
temperature drops below
152°F (67°C).Unlock the
clamps. Fully extend the +side
rails and lock the clamps
again.
The mower
does not
mulch properly
• Wet grass clippings are sticking
to the underside of the deck.
• The mower is set to cut too
much grass at once.
• Wait until the grass dries
before mowing.
• Raise the deck to a higher
cutting height setting.
Summary of Contents for 7063706
