Hensel-Visit COPY ONE, User Manual

Page: 7 / 24

User manual Copy One
HENSEL-VISIT GmbH & Co. KG 7
being changed to radiation. This plasma development then causes
positive pressure inside the flash tube. At the same time, the glass tube is
exposed to strong mechanical forces. Minimal defects of the fused quartz
glass, visually impossible to notice, may possibly lead to the explosion of
the flash tube.

In case the flash tube explodes, there is a danger of tiny glass
particles flying around. The user of this equipment needs to make
sure to protect himself by the use of the front diffuser.
 The flash tube can only explode during the flash process.
Therefore, the flash head should never be directed at a person
during flashing.

Immediately disconnect the flash head from the generator if the
flash tube becomes damaged. Electrodes carry high voltage!

Flash tubes must only be changed by authorized and trained
personnel.

The flash tube must only be changed after the device is
disconnected from the power supply and is completely discharged.
Risk of Burns from Reflector and Flash Unit
After flashing there is a risk of burns caused by the reflector and the flash
unit due to hot parts on the housing or infrared heat radiation.