Hensel-Visit Certo 200, User Manual

Page: 37 / 56

Operating the device
37
Activating and deactivating the model light
“Prop” mode
To activate the model light in “Prop” mode, proceed as follows:

Press the LAMP button.
The LED display next to the LAMP button lights up green. The brightness of
the model light is proportional to the set flash energy.
To deactivate the model light in “Prop” mode, proceed as follows:

Press the LAMP button twice.
The LED display next to the LAMP button goes out.
“Full” mode
To activate the model light in “Full” mode, proceed as follows:

Press the LAMP button twice.
The LED display next to the LAMP button lights up red. The model light
illuminates at maximum brightness, irrespective of the set flash energy.
To deactivate the model light in “Full” mode, proceed as follows:

Press the LAMP button again.
The LED display next to the LAMP button goes out.
Checking the function of the model light
When the model light illuminates, the LED display next to the LAMP button
lights up. If it does not light up, proceed as follows:

Press the LAMP button.
The LED display next to the LAMP button lights up green.

If the model light does not light up despite an illuminated LED display
next to the LAMP button, check the illuminant and the fuse.