Henny Penny LVE-202, Technical Manual

Page: 81 / 115

Maintenance
69
T Th he e ffo ollllo ow wiin ng g p prro occe ed du urre e o on nllyy
a ap pp plliie ess tto o u un niittss m ma an nu uffa accttu urre ed d p prriio orr
tto o S Se ep ptte em mb be err 2 20 01 18 8.. F Fo orr u un niittss
m ma an nu uffa accttu urre ed d a afftte err S Se ep ptte em mb be err
2 20 01 18 8,, e en nttiirre e p pu um mp p a asssse em mb bllyy m mu usstt
b be e rre ep plla acce ed d.. F Fo ollllo ow w p prro occe ed du urre e
a acccco orrd diin ng g tto o m ma an nu uffa accttu urre e d da atte e,,
o otth he errw wiisse e p prro op pe errttyy d da am ma ag ge e m ma ayy
o occccu urr..
2 2))
Install a new seal kit (part no. 17476) onto shaft of motor.
3 3))
Align the motor shaft motor with the pump rotor on the inside of pump body and
push pump on motor shaft.
4 4))
Secure the pump to the motor with the two bolts.
7 7..1 15 5..5 5 A Ad djju usstt P Pu um mp p & & M Mo otto orr A Asssse em mb bllyy P Po ossiittiio on n
1 1))
Loosen bolts and nuts securing assembly to bracket.
2 2))
Slide filter pan in under fryer on the rails until it rests against drain trough nozzle
so drain pan cover opening is aligned with nozzle.
3 3))
Check to be sure drain pan latch fully engages pan with about 1/16 inch (2-3
mm) of play. Adjust as needed.
4 4))
Move pump and motor assembly so both O-rings on drain pan fully engage Plug
and Play connector and no O-ring is visible.
5 5))
Tighten bolts and nuts securing assembly to bracket.