Henny Penny LVE-202, Technical Manual

Page: 79 / 115

Maintenance
67
3 3))
To reassemble, place rotor on drive shaft, and place roller into rotor.
T Th he erre e iiss a an n iin nd diicca atto orr o on n tth he e ssiid de e o off tth he e
ttw wo o h ha allvve ess o off tth he e p pu um mp p,, tth hiiss m ma arrkk
m mu usstt b be e tto og ge etth he err..
NOTICE A small amount of grease might be
needed to hold the bottom roller into
place until cover plater is put on. Make
sure O-ring is in proper position on plate.
7 7..1 15 5..2 2 R Re esse ettttiin ng g T Th he errm ma all O Ovve errllo oa ad d S Sw wiittcch h
1 1))
Open middle door, locate pump and motor above drain pan and if the motor is
hot, allow it to cool for about five minutes.
2 2))
Since it takes some effort to reset the switch, use a tool, such as a Phillip’s-head
screwdriver, to press against the reset button until an audible click is heard.
7 7..1 15 5..3 3 R Re ep plla acciin ng g tth he e F Fiilltte err P Pu um mp p a an nd d M Mo otto orr A Asssse em mb bllyy
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff a an nd d
d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un n--
p pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
1 1))
Open the right door and remove JIB from fryer.
2 2))
Open door to the left of the JIB and remove the drain pan.
3 3))
Using a 1 inch wrench, disconnect the line at the elbow or tee on the front of the
pump.
4 4))
Using a 1 inch wrench, disconnect the line at fitting on the rear of the pump.