Henny Penny LVE-202, Technical Manual

Page: 69 / 115

Maintenance
57
2 2))
Using a 3/8 inch wrench or socket, remove two mounting nuts on base plate of
contactor begin replaced and remove contactor.
3 3))
When replacing the heat contactor, slide it from the mounting rail.
4 4))
Install new contactor in reverse order.
5 5))
Reconnect power to the fryer and test for proper operation.
6 6))
Support control panel bottom with one hand, swing panel top up about 90
degrees, slide panel down slightly to clear screw head, push panel top up to
engage screw, then tighten screw.
7 7..1 13 3 S Se elle ecctto orr V Va allvve e
All vats are plumbed into the selector valve. It controls the flow of oil into and out of
each vat. It is a rotary valve operated by a low voltage motor.
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff a an nd d
d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un n--
p pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
7 7..1 13 3..1 1 M Mo otto orr R Re ep plla acce em me en ntt
1 1))
Using a 1/8 inch Allen wrench, loosen two screws and remove chain guard.