Henny Penny LVE-202, Technical Manual

Page: 65 / 115

Maintenance
53
7 7..1 11 1 E Elle em me en ntt S Se en nsse e S Sw wiittcch h
This switch removes power to the element when the element is raised. If a constant
“E-31” “HEATING ELEMENTS ARE UP” is shown on display when elements are
lowered into vat, check element safety switch.
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff a an nd d
d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un n--
p pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
7 7..1 11 1..1 1 C Ch he ecckko ou utt
1 1))
Support control panel bottom with one hand, loosen retaining screw at control
panel top, slide panel down slightly to clear screw, push panel up, swing panel
top out and down.
2 2))
Refer to decal on control panel back, locate P9 connector (left vat - split vat) or
P10 connector (full or right vat).
3 3))
Pull connector from panel and using multimeter, check for continuity between
two appropriate pins (labeled “HEAT SWITCH”). With safety switch plunger
pushed in (element lowered), circuit should be closed. With element up, circuit
should be open. If switch is faulty, replace switch.
7 7..1 11 1..2 2 R Re ep plla acce em me en ntt
1 1))
Remove six screws and rear shroud.
2 2))
Pull the wires from the switch.