Operation 37
As an option, the machine can be equipped with a Seal 1-2 option. This means the seal wire is
activated separately from the cut-off wire. This way the cut-off wire can be activated a bit longer, to
cut through thicker bags.
To set the Seal option, follow the steps below:
1.
Press the PROG 0 – 9 button to select the program you wish to change.
2.
Press the REPROG button to select the programming mode.
The function display will start flashing.
3.
Use the Cursor key to scroll to the parameter Seal.
The LED in front of the selected function will light up.
4.
Press the – / STOP button and the + / VACUUM STOP button to adjust the value.
5.
Press the REPROG button to activate the new parameter.
The function display will stop flashing.
To change the Cut-off time:
6.
Press the Cursor key again. The LED in front of Seal will still be lit. Repeat steps 4 and 5.
6.7.1.10 Soft-Air (optional for the Falcon)
This is the time that air is softly released into the chamber after sealing has taken place.
To set the Soft-air function, follow the steps below:
1.
Press the PROG 0 – 9 button to select the program you wish to change.
2.
Press the REPROG button to select the programming mode.
The function display will start flashing.
3.
Use the Cursor key to scroll to the parameter Soft-air.
The LED in front of the selected function will light up.
4.
Press the – / STOP button and the + / VACUUM STOP button to adjust the value.
5.
Press the REPROG button to activate the new parameter.
The function display will stop flashing.
6.7.1.11 External Vacuum (optional)
The External Vacuum function allows special food containers to be vacuumed outside the machine.
Depending on whether the machine is time or sensor-controlled, the vacuum value is set in
seconds or %.
External Vacuum is only available on the Marlin series.
With the External Vacuum program, you can program as with any other program. See Changing
the Program Settings on page 33. Check in advance whether the relevant food container can
withstand and hold a vacuum.
To select the External Vacuum option, follow the steps below.
1.
Select the External Vacuum program.
a.
Press the Pump Cleaning Program button.
The display will show "C".
b.
Press the Cursor key.
The display will show "E".