15
EN
NOTE:
Pay close attention to the order of mount assembly
parts, as they have been correctly assembled by the factory
(see 3A). Also, reference the cushion mount detail in illus-
tration 3G for the proper position of the cushion mount.
NOTE:
Try practicing this assembly before you get under
the sink to get the “feel” of how the parts fit together.
A. Disassemble mount assembly from disposer by turning
mount ring to the left (clockwise) and remove.
SPEED MASTER MOUNT SYSTEM
B. Raise mount ring toward top of sink flange. Remove cushion
mount. Remove mount ring. You may want to practice in-
stalling the cushion mount at this point before you are
under the sink. See paragraph H. Also see the “Important
Notice: Cushion Mount Detail.”
C. Unscrew support ring from sink flange and remove fiber
gasket. You are now left with sink flange and rubber gasket.
D. The rubber gasket is used instead of plumbers putty with
stainless steel sinks. Other sinks will require putty.
E. If no putty is used, insert sink flange through rubber gasket
into sink opening. Do not rotate sink flange once it is seated.
F. If you use putty instead of the gasket, form a ring around
underside of sink flange (see 3D). Insert flange into sink
opening, press down hard to squeeze out excess putty
(see 3B). From under sink, trim off excess putty flush with
bottom edge of sink opening.
G. From underneath sink, slip fiber gasket onto exposed
sink flange. With arrows pointing up, screw support ring
onto the sink flange, hand tighten until the sink flange
will not move. At this point you may want to insert stopper
in sink and fill with water to check sink flange seal and
ensure there are no leaks.
H. Place mount ring over sink flange and hold in place while
installing cushion mount (large side down) so the groove
on the inside of cush- ion mount fits over lip on sink
flange, similar to putting the lid on a plastic container
(see 3E, 3F & 3G). Please read important notice below.
I. The disposer must be installed so that the reset button
is readily accessible.
CHAPTER 3. INSTALLATION OF MOUNTING ASSEMBLY
READ COMPLETELY BEFORE STARTING
3
sink flange
sink flange
gasket
support ring
fiber gasket
cushion mount
removeable
splash guard
stopper
removeable
splash guard
sink flange
rubber sink flange
gasket (or putty)
fiber gasket
supporting ring (note
arrows indicating up)
tightening ears
cushion mount
mount ring
dishwasher inlet
hopper
sink
groove
elbow gasket
screws
elbow flange
discharge
elbow
reset button
(front)
3A
3B
