GLOBE-410W
10W Pendant Ceiling Speaker
7
7
8
9
7.
Screw the plastic cylinder and adjust the
perpendicularity of the aluminum stick,
so as to be perfectly aligned.
8.
Hang the diffuser on the hook using the
two holes on the upper end of the stick.
9.
Push the plastic cup upwards to com
-
pletely cover hook and electric wires, and
tighten the star screw to secure the glass.
The installer is responsible of installation. Please pay attention to
install speakers according to local safety regulations.
When mange these speakers, be careful not to touch or load the front
of the speaker net with hard facing, otherwise it will deform the net.
5.2. Speaker Connection
GLOBE-410W speaker is equipped with a built-in line transformer with 2 power
taps, to better adapt each speaker to the type of line (constant voltage @ 70V or
100V), the power of the amplifier, and the number of speakers in the system.
When connect the speaker to the 70/100V line, pay attention to wire colors. Please
refer to the following table when connect them to the line.
Wire Color
GLOBE-410W
Black
Ground
Red
5W
White
10W
6. UNDER-POWERING VS OVER-POWERING
Most speaker damages are caused by amplifiers with too little power (wattage).
Overdriven amplifiers clip output waveforms and send distortion to the speakers.
Clipping is usually audible; it may vary from a harsh sound to a fuzzy or unclear
sound.
If you hear this condition at loud volume levels, turn down the amplifier volume
until the distortion is no longer present. Damages caused by operating the speak-