8
Note:
In your Z-
Wave gateway this mode will be shown as “
Auto Changeover
”.
DRY - Fast Floor Drying Mode (Dry Air)
This mode is recommended for use if a high floor temperature is required for a limited period of time. For example, after
washing the floor. By choosing DRY Mode, the HE-HT01 will increase the temperature to the selected Set Point for the
time specified in
the “Dry Time”
Parameter (Parameter 25). A time range of 5 to 90 minutes can be set. As the Dry Time
passes, the HE-HT01 will automatically change to the Mode set in Parameter 26.
To change the Dry Time Parameter, open the “Settings Menu” by pressing the
Gears “ ” button for three seconds. Use
the “
” and “
MODE”
buttons to scroll up and down through the menu to Parameter 25. Then use buttons
“
+
” and “
–
”
to increase or reduce the Dry Time setting (in minutes).
To choose the mode to revert to after Dry
Time has elapsed (while still in the Settings Menu), press the “
” or “
MODE”
button
to select Parameter 26, then use buttons
“
+
” and “
–
” to choose the desired Mode as follows:
Mode:
COM
TIME
DRY
ECO
VAC
MAN
Value:
1
2
n/a
4
5
6
Notes:
This is the factory default for revert after DRY Mode (Parameter 8)
You cannot revert to DRY Mode.
If MAN Mode is chosen, the HE-HT01 will select IDLE state
Note:
Factory defaults for Dry Time are: 30 minutes at 30.0°C.
Note:
In your Z-
Wave gateway this mode will be shown as “
Dry Air
”.
ECO - Energy Saving Mode (Energy Save Heat)
This Mode can be used if lower temperature and energy consumption is desired. It can also be used at night or when
away from all or part of the property for a length of time. The factory default ECO Set Point is 20.0°C.
Note:
In your Z-
Wave gateway this mode will be shown as “
Energy Save Heat
”.
VAC - Vacation Mode (Away)
Use Vacation Mode when you are planning to be away from home for some period. The factory default temperature Set
Point is 15.0°C.
Note:
The minimum set point for each mode is 1.0°C and the maximum set point is 37.0°C.
Note:
In your Z-
Wave gateway this mode will be shown as “
Away
”.
MAN - Manual Control Mode (Off)
In this Mode the HE-HT01 schedules are disabled and the heating state is switched On & Off manually by pressing the
Heating Element “
” button.
Note:
When in Manual Control Mode the
“
SET TEMP
”
will indicate “OFF”
.
Note:
In your Z-
Wave gateway this mode will be shown as “
Off
”.
Child Lock (LOC)
The Child Lock feature allows you to disable the HE-HT01 touch buttons temporarily. To activate the Child Lock Mode,
press and hold the Heating Element “
” button for five seconds until the Lock Icon “ ” appears in the bottom center of
the display. To deactivate the Child Lock, press the Heating Element “
” button until the Lock Icon “ ” disappears.
Factory Reset (RES)
B
y pressing and holding the “MODE”
button for six seconds, the HE-HT01 will enter Factory Reset Mode, displaying
“
REs
” in the left bottom corner, “
y
” in top left corner and “
n
” in top right corner. Press the Plus “
+
” button to revert to factory
settings, or
the Heating Element “
” button to cancel. The factory reset will change all the Parameters to their original
factory default values (including Z-Wave frequency) and will also Exclude the device from any Z-Wave network.
Note:
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
