……………………………………………………………………………………………………………………….
Subject to technical modifications
Date of August / 2019
1
/
2
ONYX.CLICK/ ONYX.CENTER
Stand alone system to expand ONYX.CENTER
Introduction
In these instructions we explain you, how you can expand an existing ONYX
®
stand-alone system by
ONYX.CENTER (Smart Home Control). The following step-by-step instructions exactly describe this
precedure.
Preparation
For the setup of ONYX.CENTER, the
QR code list
of all control devices / wind sensors is required.
This list was included in the delivery.
Before a setup of the ONYX.CENTER is possible, the connection between the control devices/ (if
available) the weather sensor and the hand-held radio transmitter ONYX.CLICK must be
disconnected. The easiest way to do this is a short
voltage interruption
(1)
of the control devices/
weather sensor.
If a voltage interruption
(1)
of the ONYX
®
products is not possible, the following steps must be taken:
-
Setting up of a connection to the corresponding hand-held transmitter via the ONYX
®
app.
(see operating instructions ONYX.CLICK)
-
Delete all devices under
“Configure devices”
For this purposes, the
“Pencil symbol”
is
selected for each device, and the device is then deleted under
“Advanced settings”
.
It is important, that all control devices/ weather sensors, which you want to control
later via ONYX.CENTER, are deleted from the corresponding hand-held transmitters.
-
Interrupt the connection to the hand-held transmitter. (
“Done”
/
“Complete”
)
Configuration
Now the ONYX.CENTER must be setup and configured as given in the
operating instructions
enclosed
. As soon as a connection between ONYX.CENTER and the ONYX
®
app is set up, the
system can be setup as follows:
-
Under consideration of the operating instructions enclosed, all control devices and weather
sensors are scanned in ONYX.CENTER, in the ONYX
®
app.
For this purpose the QR code
list is required!
-
Now the hand-held radio transmitter ONYX.CLICK is scanned.
In order to do this the
connection to ONYX.CENTER in the ONYX
®
app must not be disconnected.
By tapping
on the
“+”
symbol (
“Scan device”
), the QR code provided at the back side of the
ONYX.CLICK, can be scanned.
Attention: Ensure that the configuration mode is
activated!
-
The two buttons (groups and heart) provided at the hand-held radio transmitter must now be
pressed simultaneously for 3 seconds. (Connection is set up/ an update may be installed)
-
Due to the fact that the hand-held radio transmitter ONYX.CLICK was previously connected
with control devices, the menu item
“Overwrite configuration”
must now be selected.
-
Now a new name for the hand-held radio transmitter can be created. The configuration is
continued under the menu item
“Advanced settings”
.
-
Now the 5 groups are displayed. By tapping on the respective group, all control devices, which
previously were connected with ONYX.CENTER, can now be assigned to the group.
-
The settings are saved with
“Done”
/
“Complete”
.
