Heliocentris Energy Manager 1.3, Instruction Manual

Page: 43 / 78

Operating
Energy Manager 1.3 - Instruction Manual 43
5.1.7 Aircon Submenu
Menu item Display Description I/C
OpMode One of the
modes
Operating mode of the air
condition system. The mode is
also displayed in the main menu if
no error occurred.
init Software module initializes. I
active Aircon module is active.
offline Aircon module is offline and will
not be started by the EM control
software. I
standby Aircon is available, but is not used
in the moment.
I
error Aircon module is in error status. I
StateRpl One of the
replies: State reply. System answer on a
user command (CMD).
init Software module initializes. I
run Aircon module reports “Ready for
operating”. I
offline Aircon module reports request to
switch as soon as possible to
OpMode “offline”. I
test Aircon module indicates that it is
in “Test mode”.
I
CMD One of the
commands:
Commands to be entered by user.
no command No command stands in a queue. I+C
go online Start Aircon module C
go offline Stop Aircon module C
go testmod Set Aircon module to test mode C
cancel
command
Cancel command in queue C
Temp x.x °C Temperature at outlet of Aircon I
Current x.x A Current consumption of Aircon (if
sensor is installed) I
Prio xxxx Priority value of the Aircon I
Op-Time x.xx h Operating hours of Aircon I
Reset counter* Resetting operating counters C*
Error List Number in
hexadecimal
format
All active events are displayed one
after another with their number
and a short text and can be
confirmed.
I+C
Legend:
* Item is only displayed if the access level is service
I/C Information/Command
Table 5-7 Aircon submenu