Getting Started
Energy Manager 1.3 - Instruction Manual
25
1.
Check the polarity of the supply cables.
2.
Insert the cables into the connector and tighten the screws.
3.
Insert the connector with the positive plug (2) into the left side and the
negative plug (1)into the right side.
TIP
Different supply voltages or polarities are possible. This requires
hardware changes like a different main adapter or different jumper
settings in the power supply board.
Contact the Heliocentris Service.
4.6
How to Use the Control Panel
4.6.1
Operating Areas of the Control Panel
The control panel comprises the different operating areas of the Energy
Manager. The operating areas are shown in the following figure and
explained further on:
Figure 4-2 Control panel
1
LED system status
2
4-line 20-character LCD
3
Control key <left>
4
Control key <up>
5
Control key <OK>
6
Control keys <right>
7
Control keys <down >
8
Reset button
LED
The LED (light-emitting diode) indicates the system status by using the
following symbols and colors:
Symbol
Color
Description
Red
Critical system status, one of the
installed modules is in error status.
Yellow
System is still in operating, pending
information e. g., warning or
