Heliceo Fox6, User Manual

Page: 29 / 73

29 V1.1
7. Switch the Fox6 ON
1- Switch ON the Radio Controller (RC). To avoid triggering a bad start alarm of the RC, set all
switches down, and verify that the throttle is on the idle position (in the lowest position). If one of
the switches or sticks is in a bad position, the RC will raise a message when the RC is switched
ON.
Switches
throttle
2- Test the battery charge level, with the battery tester. In full charge, the battery voltage is in
the 16,6v and 16.8V range. Each battery element should be around 4,20V, which can be
individually checked with the
«
CELL
»
button.
3- Attach the battery in the specific battery compartment. Connect the black power cable (-)
and then the red power cable (+). The
Fox
6 starts beeping. An automatic electronic check will
be progressing (with different color phases). Note that Fox 6 and Fox Bathy batteries are
exchangeable.