Cover plate set 75 Flow (curved) -installation
1. Measure and mark the
fi
xing height of the Track
The screw holes on the SKX brackets are
door + 86 mm
.
(For SK brackets, the installation height is a door + 88 mm).
This leaves a 9 mm gap between the
fl
oor and the door. NB! If the
fl
oor is uneven, measure the height at the highest point of the
fl
oor.
After marking one point, draw a horizontal line on the wall using the
spirit level along the entire track. This is how you mark the horizontal
locations of the screws for each bracket.
With the mounting bracket bolt you can adjusts the height of the door
by approximately ± 2 mm after installation.
2. Slide the Wall brackets to the track
Slide the bracket lightly from the center so that it slides straight and
e
ff
ortlessly along the groove. Do not use force to prevent the bracket
from “clipping”.
3. Mount the Brackets and the Track to the wall
and
fi
nally tighten the clamping screws on the
Brackets
If you are working alone,
fi
rst tighten the center bracket to the wall with
one screw so you can easily support the track when mounting the
other brackets.