Heiniger Xperience/C, Translation Of The Original Instructions

Page: 35 / 220

Translation of the original instructions / Cattle clipper Xperience
17
Malfunction Cause Rectification
Shearing machine cuts
badly or not at all.
shearing blade is blunt. Notify customer service.
Clipping blades have not
been correctly ground.
Clipping blades are not oiled. Lubricate the clipping blades
every 15 minutes.
Clipping pressure too low. Increase the clipping pressure as
described in chapter 6.2.
Leaf springs broken. Notify customer service.
The animal‘s hair is wet. Only clip dry hair.
Hairs jammed between top
and bottom blades.
Remove the clipping blades;
clean, lubricate and install them
again; set the clipping pressure.
Too much play at the clipper
head.
Notify customer service.
Clipping blades not properly
aligned.
Align the clipping blades
correctly, see Fig. 9.
Motor unit becomes hot. Air filter clogged. Clean or replace the air filter.
Clipping pressure too high. Reduce the clipping pressure.
Bearing faulty. Notify customer service.
8 Spare parts
See spare parts list at the end of these operating instructions.
CAUTION!
FAULTY SPARE PARTS MAY CAUSE DAMAGES, MALFUNCTIONS
OR TOTAL LOSS AND MAY REDUCE SECURITY.
X
Use only original spare parts from the manufacturer. Obtain
spare parts from an authorised dealer or directly from the
manufacturer.
NOTE!
X
If non-approved parts are used, all warranty, service,
compensation and liability claims against the manufacturer or
its employees, dealers and representatives will be forfeited.
During the warranty period the device must be opened only by personnel
authorised by the manufacturer, otherwise the warranty will be void.
Pos. No. Description Quantity
Shearing machine
1 Clipper head cattle complete 1
2 Tension nut cattle 1
3 Distance screw 1
4 Tension sleeve 1
5 PH-screw M5 x 14 2
6 Clipper head case 1
7 Pressure spring 1
8 Pressure plate 1