HEIL DuraPack 5000 2017, Operation Manual

Page: 119 / 204

Issued September 2017
On-Route Operation Procedures Copyright 2017, Heil Environmental
Printed in U.S.A.
111
DuraPack
®
5000
LOADING REFUSE MANUALLY (CONTINUED)
Packing Refuse into the Body
CAUTION
The upper panel in/out and blade up/down operations can
push refuse out of the hopper or break objects. Refuse
broken by the blade can cause moderate or minor injury.
Stay clear of the packer panel during upper panel in/out
and blade up/down operations.
3. The In-Cab Packer Switch should be ON.
4. Make sure the tailgate is LOCKED.
5. Sweep the refuse from the hopper and pack it into
the body.
a. PULL the upper panel and blade levers at the
same time and RELEASE the levers. The levers
will self-center at the end of the commanded
position by way of valve internal hydraulic
pressure. See the figure below.
Figure 58. Loading Refuse
b. The upper panel will move OUT and the blade will
move UP. STOP the blade UP operation when the
blade is at the pinch point with the hopper sill.
c. Watch for refuse that is pushed out of the hopper.
d. PUSH the upper panel and blade levers at the
same time and RELEASE the levers. The levers
will self-center at the end of the commanded
position by way of valve internal hydraulic
pressure. See the figure below.
e. The upper panel and blade move and compact
the refuse into the body.
Figure 59. Packing the Refuse
6. Repeat Steps 1 and 5 as necessary to compact the
refuse.
7. Leave the blade against the refuse.
8. Move the refuse container to its pick-up location.