HEIL DuraPack 5000 2017, Operation Manual

Page: 109 / 204

Issued September 2017
Before Going on Route Copyright 2017, Heil Environmental
Printed in U.S.A.
101
DuraPack
®
5000
PREPARING THE UNIT TO CHECK THE
HYDRAULIC OIL LEVEL
Before checking the oil level or adding oil, make sure the oil
is warmed up and the unit is in the following position with all
cylinders collapsed:
Truck – on level ground
Tailgate and Body – fully down and locked
Ejector Panel – at the front of the body
Packer Panel – in the in-transit position with all
cylinders retracted
CHECK HYDRAULIC OIL LEVEL
Check the hydraulic oil level (after warming up the oil) daily
or every eight (8) hours, whichever comes first. Fill as
necessary.
Cycle All Hydraulic Functions
Follow These Steps:
1. Operate the packing panel, and body and tailgate
functions two or three times each. See Section 3
for proper operation of controls.
2. Put the unit back in the position described above and
check the oil level again.
3. Add oil if necessary. See the “Recommended
Hydraulic Oil” chart below. Refer to the Service
Manual for instructions for filling the oil tank.
RECOMMENDED HYDRAULIC OIL
The following oils by brand name are approved for use in
the hydraulic system on this equipment and considered to
be all-temperature hydraulic fluids:
Shell Tellus T32
Mobil DTE 13M
Texaco Rando HDZ 32
NOTE: Cold weather operation requires special oil
considerations. Viscosity should not exceed 7500 SSU at
lowest startup temperature. Continuous operation should
range between 40–1000 SSU for all temperature ranges.
NOTICE
Contamination is a hydraulic system’s worst enemy. DO
NOT let dirt enter the system. Use a clean rag and remove
dirt or other contamination around any system component
before you disconnect or remove it. While you fill the
reservoir, filter the oil through a 200 mesh (or finer)
screen. NEVER use a cloth to filter the oil.
61