HEIL DuraPack 5000 2017, Operation Manual

Page: 107 / 204

Issued September 2017
Before Going on Route Copyright 2017, Heil Environmental
Printed in U.S.A.
99
DuraPack
®
5000
BATTERY DISCONNECT SWITCH
The battery box is typically located on the streetside of the
chassis frame near the front of the body, however it can be
mounted at a different location on different chassis.
Become familiar with the location of the battery box and
battery disconnect switch on your unit.
1. You must turn the battery disconnect switch to the
OFF position whenever the unit is shut off for any
length of time – especially when the unit will be left
unattended.
2. You must turn the battery disconnect switch to the
ON position whenever you will use the unit.
3. You must check the position of the battery
disconnect switch as part of the daily inspection.
NOTICE
Battery cables must be securely anchored and not rubbing
other equipment. Cable insulation must be free of damage
and abrasion. Inspect weekly.
NOTICE
Always disconnect the battery before welding on the
chassis or body.
DAILY CHECKLIST
See the Daily Check section for the daily checks and
procedures checklist. Make a copy of the check list.
WARNING
A unit that needs service or repair can malfunction and
create a dangerous condition. A part failure during
operation can cause serious injury or death to a person or
damage to the unit. Repair or replace any failed or
defective part immediately.
83