HEIDENHAIN TNC 640, User Manual, Page: 877 / 948

MOD Functions | Configuring the HR 550FS wireless handwheel
20
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
877
20.15 Configuring the HR 550FS wireless
handwheel
Application
Press the
SET UP WIRELESS HANDWHEEL
soft key to configure
the HR 550FS wireless handwheel. The following functions are
available:
Assigning the handwheel to a specific handwheel holder
Setting the transmission channel
Analyzing the frequency spectrum for determining the optimum
transmission channel
Select transmitter power
Statistical information on the transmission quality
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1 this device may not cause harmful interference
2 this device must accept any interference received,
including interference that may cause undesired
operation
Assigning the handwheel to a specific handwheel
holder
Make sure that the handwheel holder is connected to the
control hardware.
Place the wireless handwheel you want to assign to the
handwheel holder in the handwheel holder
Press the
MOD
key to select the MOD function
Select the
Machine settings
menu
Select the configuration menu for the wireless handwheel:
Press the
SET UP WIRELESS HANDWHEEL
soft key
Click on the
Connect HW
button
The control saves serial number of the inserted wireless
handwheel and shows it in the configuration window on the
left next to the
Connect HW
button.
To save the configuration and exit the configuration menu,
press the
END
button