HEIDENHAIN TNC 640, User Manual, Page: 822 / 948

Test Run and Program Run | Test run
19
822
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Test Run
up to a certain block
With the
STOP AT
function the control executes a
Test Run
up to
the block with block number
N
.
Proceed as follows to stop the
Test Run
at any block:
Press the
STOP AT
soft key
Stop at: N =
Enter the block number at which
the simulation should stop
Program =
Enter the name of the program
containing the block with the selected block
number
The control shows the name of the selected
program.
If the simulation is to be stopped in a program
that has been called using
PGM CALL
, then enter
this name
Repetitions =
If
N
is located in a program section
repeat, enter the number of repeats that you
want to run.
Default 1: The control stops before
N
is
simulated
Possibilities in stopped condition
If you interrupt the
Test Run
with the
STOP AT
function, you have
the following possibilities in this stopped condition:
Block skip
enable or disable
Optional program stop
enable or disable
Modify graphics resolution and model
Modify the NC program in the
Programming
operating mode
If you modify the NC program in the
Programming
operating mode
the simulation behaves as follows:
Modification before the interruption point: The simulation
restarts at the beginning
Modification after the interruption point: Positioning at the
interruption point is possible with
GOTO