HEIDENHAIN TNC 640, User Manual, Page: 795 / 948

Manual Operation and Setup | Camera-based monitoring of the setup situation VSC (option 136)
17
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
795
Configuration
You have the option of changing your settings for the monitoring
area and errors at any time. When you press the
CONFIGURE
soft
key, the soft key display changes and you can change your settings.
Soft key Function
Change settings for the monitoring area and sensi-
tivity
If you make a change in this menu, the results of
the image evaluation may change.
Draw new monitoring area
If you add a new monitoring area, or change/delete
monitoring areas already set, this will have an
effect on the image evaluation. The same monitor-
ing area applies to all reference images.
Draw new error
The control checks if or how the new settings
affect this image
The control checks if or how the new settings
affect all images
The control shows all drawn monitoring areas
The control compares the momentary image with
the mean image
Save current image and return to the previous
screen
If you change the configuration, the control carries
out an image evaluation.
Discard images and return to the previous screen
You can also zoom the image with the buttons and shift the
magnified image section with the mouse or arrow keys.
To draw the monitoring area or error area
Proceed as follows:
Press the appropriate soft key, e.g.
DRAW AREA
Click on the image and select the area with the mouse
The control indicates the clicked area with a frame.
Shift the area if required by holding down the mouse button
You can fix the drawn area by double-clicking it, thereby protecting
it from unintentional shifting.