HEIDENHAIN TNC 620, User Manual

Page: 68 / 521

Fundamentals | Status displays
3
3.4 Status displays
General status display
The general status display in the lower part of the screen informs
you of the current state of the machine. The control displays
information about axes and positions, as well as technology values
and icons for active functions.
The control displays the status in the following operating modes:
Program run, single block
Program run, full sequence
Positioning w/ Manual Data Input
If the
GRAPHICS
screen layout is selected, the status
display is not shown.
In the
Manual operation
and
Electronic handwheel
operating
modes, the control shows the status display in the large window.
Axis display and position display
Refer to your machine manual.
The sequence and number of displayed axes is defined
by the machine tool builder.
Icon Meaning
ACTL Position display mode (e.g., actual or nominal
coordinates of the current position)
Further information: "Selecting the position
display", Page 345
Machine axes
The selected axis is highlighted
The control displays auxiliary axes in lowercase
letters
Axis has not been homed
Axis is not in safe operation or it is simulated
Axis is locked
Axis can be moved with the handwheel
The machine parameter
CfgPosDisplayPace
(no. 101000)
defines the display accuracy by the number of decimal
places.
68
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022