HEIDENHAIN TNC 620, User Manual

Page: 447 / 521

HEROS functions | User administration
HEROS role name Description
NC.EditTableAdv Additional table programming functions (e.g., editing of the table head)
HEROS.SetTimezone Adjustment of date and time, time zone and time synchronization via NTP and the
HEROS menu
.
HEROS.SetShares Configuration of public network drives mounted on the control
HEROS.MountShares Connecting and disconnecting network shares with the control
HEROS.SetNetwork Configuration of network and relevant settings for data security
HEROS.BackupUsers Data backup on the control—for all users configured on the control
HEROS.BackupMachine Backup and restoring data of the entire machine configuration
HEROS.UserAdmin Configuration of user administration on the control
This includes creating, deleting and configuring local users
HEROS.ControlFunctions
Control function of the operating system
Auxiliary functions, such as starting and stopping NC software
Telemaintenance
Advanced diagnostic functions, such as log data
HEROS.SWUpdate Installation of software updates for the control
HEROS.VMSharedFolders Access to shared folders of a virtual machine
Only relevant when running a programming station within a virtual machine
NC.RemoteProgramRun NC program start from an external application, e.g. via the DNC interface
NC.ConfigUserAdv Configuration access to the contents that have been enabled through code
number
123
NC.Data.AccessServiceRead Read-only access to the
PLC:
drive during servicing
Enabling
Autologin
When the
Autologin
function is enabled, during startup the control
automatically activates a user defined by you, without the need to
enter a password.
As opposed to the
Legacy-Mode
, this enables you to restrict a user's
rights without entering a password.
For further authorizations, the control still requires an authentication
to be entered.
In order to enable
Autologin
, the following requirements must be
met:
User administration has been configured
The user for
Autologin
has been defined
Proceed as follows to enable the
Autologin
function:
Call the user administration
Select the
Settings
tab
Press the
Global settings
soft key
Tick the check box for
Enable autologin
The control opens a window for selecting the user.
Select the user
Enter the user's password
Press the
OK
soft key
10
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
447