HEIDENHAIN TNC 620 Programming Station, User Manual

Page: 308 / 695

Subprograms and program section repeats
8.2 Subprograms
8
308
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
Program the subprogram
To mark the beginning: Press the
LBL SET
key
Enter the subprogram number. If you want to use
a label name, press the
LBL NAME
soft key to
switch to text entry.
Enter the text
Mark the end: Press the
LBL SET
key and enter
the label number
0
Calling a subprogram
Call a subprogram: Press the
LBL CALL
key
Enter the subprogram number of the subprogram
you wish to call. If you want to use a label name,
press the
LBL NAME
soft key to switch to text
entry.
L 0
is not permitted (Label 0 is only used to mark the
end of a subprogram).