9-6
9
External Data Transfer
TNC 426/TNC 425/TNC 415 B/TNC 407
Data Transfer with the TNC 425, TNC 415 B and TNC 407
When aborting blockwise transfer, you may have to reset the interface with the CLOSE RS-232-C soft key.
Fig. 9.1:
Menu for blockwise transfer
Transferring files from an external device to the TNC
Use the cursor key to move the highlight to a file that is stored in the
external device.
Function
Soft key
Transfer selected file
Transfer all files
Select files consecutively for individual
transfer. Press ENT to transfer,
otherwise press NO ENT
Interrupt transfer
You can interrupt data transfer by pressing the END key or the END soft
key.
• If the TNC recognizes erroneously transferred program blocks, it will mark them with ERROR =.
These blocks must then be corrected in the PROGRAMMING AND EDITING mode.
• If you want to transfer files between two TNCs, start transmission from the receiving TNC.
Blockwise transfer
The menu to the right is for blockwise transfer (see
page 3-11). First select as usual the name of the file
to be transferred blockwise. Then start data
transfer with the SELECT soft key.
